Webasto DBW 46 Wartungshandbuch PDF herunterladen (Seite 6)

BBW 46 / DBW 46

1 Introduction

103

• Fuel reservoirs for carburettor fuel must not be located

immediately behind the vehicle front fairing. They

must be away from the engine to prevent fuel fires in

case of accidents. This does not apply to towing

vehicles with open cockpit.

All fuel reservoirs offered in the Webasto Accessories

Catalogue are suitable for a maximum operating pressure

of 0.15 bar overpressure.

All fuel reservoirs offered in the Webasto Accessories

Catalogue are individually subjected to pressure testing

during the manufacturing process with a minimum of

0.15 bar overpressure.

• The fuel reservoirs must be provided either with a

vented seal or any other type of venting facility (vent

line).

Only sealing caps in accordance with DIN 73400 may be

used.

• The heater mode of operation - at least "on" or "off" -

must be clearly visible.

• The retrofit of a heater must be checked by an

officially authorised expert or inspector of the

Technical Supervisory Association (TÜV) in

accordance with § 19, para. 2 StVZO. With this

expertise a new vehicle operating license must be

applied for with the administrative authority (vehicle

licensing agency).

• Non-authorised installations will void the heater's

marks of conformity (ABG)and thus the vehicle's

permit of operation (ABE). The same applies to

unskilled repairs or repairs not using original spare

parts.

1.6 Corrections and Improvements

Deficiencies, improvements, or proposals for correction of

this workshop manual are to be mailed to:

Webasto Thermosysteme GmbH

Abt. Technische Dokumentation

D-82131 Stockdorf

Telephone: 0 89 / 8 57 94 - 5 42

Telefax: 0 89 / 8 57 94 - 7 57

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Keine Kommentare

Webasto DBW 46 Wartungshandbuch Seite 6