Webasto DBW 46 Wartungshandbuch Seite 38
- Seite / 40
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
BBW 46 / DBW 46
9 Repair
911
9.2.11 Replacement of Felt Disk in Burner Head
9.2.11.1 Removal
1. Remove heater (see 8.7.1.1).
2. Press clamping spring (6, Fig. 908) from locking pegs
(9) using screw driver.
3. Engage two screw drivers in recesses (7) and lever off
cover (1).
4. Discard O-ring (2) and gasket (8).
5. Remove felt disk (3) and ring (4) from burner head (5)
and discard.
6. Check burner head for felt deposits and contamination
and remove as required.
7. Clean glow plug orifice (10), diameter 2.5 mm.
8. Perform procedures on components after
disassembly (refer to 9.1.1).
9.2.11.2 Installation
NOTE
The felt disk is different for the fuel and Diesel versions
(see Fig. 909 and Fig. 910). During assembly all
components, except for the cover, must be renewed (O-
ring, felt disk, ring and gasket).
To increase the life of the glow plug, the ring
must
be cut
open as shown in the figure. This also happens during
manufacture of new equipment.
For equipment delivered and in use we recommend the
replacement of the ring and felt disk in combination with
the glow plug.
CAUTION
Prior to assembly cut ring open as shown. During
assembly ensure that ring is not compressed beyond
spring tension or bent.
1. Install felt ring observing assembly procedure
according to Fig. 909 (BBW 46) or Fig. 910 (DBW 46).
2. Install heater (see 8.7.1.2).
1Cover
2 O-ring
3 Felt disk
4Ring
5 Burner head
6 Clamping spring
7Recesses
8Gasket
9 Locking pegs
1
0 Glow plug orifice
1
2
3
4
5
10
9
8
Fig. 908 Removal of Felt Disk in Burner Head
6
Verwandte Produkte und Handbücher für Warmwasserbereiter & Kessel Webasto DBW 46
(41 Seiten)
(18 Seiten)
(72 Seiten)Linksys WAG54G2 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Hardware Linksys WAG54G2.
Wir stellen 1 PDF-Handbücher Linksys WAG54G2 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Kommentare zu diesen Handbüchern